search
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| docs:3d_printing_101:3d_printing_101 [2020/06/15 19:00] – [misc] note on precision and enf-of-filament sensor basz | docs:3d_printing_101:3d_printing_101 [2020/06/15 19:02] – [monitoring printer] end-of-filament sensor is not a silver bullet basz | ||
|---|---|---|---|
| Line 294: | Line 294: | ||
| i personally bought IP video camera that is powered via the same power cord as the printer itself. whenever i turn on my printer, camera is detected in the network, by the server, and recording automatically starts to NAS, for later access. nice, simple and powerful. | i personally bought IP video camera that is powered via the same power cord as the printer itself. whenever i turn on my printer, camera is detected in the network, by the server, and recording automatically starts to NAS, for later access. nice, simple and powerful. | ||
| + | as described previously, end-of-filament sensor is a great thing. your printer can then automatically pause when no more filament is available (either broken or out of the spool). keep in mind though, that this is not a silver bullet. it will neither detect filament being stuck (not moving) nor extruder loosing steps. it is worth keeping in mind. | ||
| ===== hints for failed prints ===== | ===== hints for failed prints ===== | ||
